ZigBeeForDomoticZ plugin Wiki
Blitzwolf corner
Known devices
- Contact sensor (BW-IS2)
- Electricity Metering 16A EU Plug (BW-SHP13)
- Rechargeable PIR Motion Sensor(BW-IS3)
- Temperature & Humidity Sensor with Display(BW-IS4)
- Water Leak Sensor (BW-IS5)
Currently, only the Plug was tested but all those products are Tuya based and should work.
The Temperature & Humidity Sensor share the same model name as generic one.
Electricity Metering 16A EU Plug (BW-SHP13)
Its generic name is TS0121.
To pair the device, press the power button for 5s, a blue light will flash till the pairing process is complete.
Five devices are created:
- Plug (On/Off)
- Voltage
- Power (General kWh and a P1Meter)
- Ampere
You can remove one on the unused power device. The cumulated consumption is updated each 0.01 kWh.
The power device also shows the instant power consumption. The plug doesn’t report it by itself, so the plugin polls it: this is the device parameter PowerPollingFreq, in seconds. The certified configuration of the plug (TS0121) sets it to 300 (every 5 minutes) when the device is paired; 0 disables the polling.
To change it, open the plugin WebUI, go to Management > Device Management, click on the Parameters icon of the plug and change the value, for example {'PowerPollingFreq': 120}. 120 seconds is enough for a washer, to know when the machine starts and finishes.
Bonus
Cluster On/Off (0x0006) contains two specific Attributes:
- 0x8001: It’s an Enum type (0x30), Mode 1 (0x01) turns off the red light on the button, Mode 2 (0x02) turns it on.
- 0x8002: Unknown
Blitzwolf corner
Known devices
- Contact sensor (BW-IS2)
- Electricity Metering 16A EU Plug (BW-SHP13)
- Rechargeable PIR Motion Sensor(BW-IS3)
- Temperature & Humidity Sensor with Display(BW-IS4)
- Water Leak Sensor (BW-IS5)
Currently, only the Plug was tested but all those products are Tuya based and should work. The Temperature & Humidity Sensor share the same model name as generic one.
Electricity Metering 16A EU Plug (BW-SHP13)
Its generic name is TS0121.
To pair the device, press the power button for 5s, a blue light will flash till the pairing process is complete. Five devices are created:
- Plug (On/Off)
- Voltage
- Power (General kWh and a P1Meter)
- Ampere
You can remove one on the unused power device. The cumulated consumption is updated each 0.01 kWh.
The power device also shows the instant power consumption. The plug doesn’t report it by itself, so the plugin polls it: this is the device parameter PowerPollingFreq, in seconds. The certified configuration of the plug (TS0121) sets it to 300 (every 5 minutes) when the device is paired; 0 disables the polling.
To change it, open the plugin WebUI, go to Management > Device Management, click on the Parameters icon of the plug and change the value, for example {'PowerPollingFreq': 120}. 120 seconds is enough for a washer, to know when the machine starts and finishes.
Bonus
Cluster On/Off (0x0006) contains two specific Attributes:
- 0x8001: It’s an Enum type (0x30), Mode 1 (0x01) turns off the red light on the button, Mode 2 (0x02) turns it on.
- 0x8002: Unknown